From Hang Gliding Wiki
Jump to: navigation, search

I know my sensor, and a lot of other gliders there is always 1 or two tip battens that are really tight(the old style with string) and hard to pull the second loop over the batten tip


skip the 3rd batten from the tip(this is bungy on my sensor) and jump to the outer two, these are the tight ones, hook the bottom of the draw coord onto the batten tip, now take the 3rd batten stick it thru the top loop, and onto the end of the batten tip you are installing, use the batten to lever the cord into place, and then just slide the batten out and go to the next one, then install the batten you were using as a tool it only takes about a half a second to do, and is easy on your fingers.